Doors up to 180 sq.
Panel lift doors installation instructions.
Installation by any person who is not a professional garage door installer is not recommended and injury or damage can result.
Review or inspect proposed installation area.
Some examples of our panel lift garage door installations.
Step plate lift handle installation drill two 2 1 4 holes straight through the center stile using the two dimples near the bottom of the section as a template.
Auto openers sectional opener panel lift panel sectional garage door opener.
Brackets to the door panel as shown in fig.
1300 42 88 66.
Installation videos manuals.
Ian s garage door centre.
Auto openers panel lift garage doors opener.
Panel lift door installation.
Installation by any person who is not a professional garage door installer is not recommended and injury or damage can result.
Either the lift handle plates 18 from the edge on the bottom panel or the.
Sectional door installation guide 6 of 20 section 1.
Speciality door installations next next album.
Install the step plate lift handle outside inside using 2.
Shown is a single center hinge door your application may have more center stiles and center hinges.
Pre installation checks a sectional overhead door is designed to be fitted behind the opening so the following dimensions need to be checked before fully unpacking the door for installation.
If the door is supplied with reinforcement struts attach the strut as shown inset.
Doors up to 18 feet 5 5 m wide.
Disclaimer these instructions and other documents are intended for professional garage door installers.
The top brackets are secured using four tek screws.
Do not install final panel until step 17.
Panel lift doors october 9 2016.
High lift up to 54 inches 137 2 cm high and standard lift sectional doors up to 14 feet 4 3 m high.
The garage door opener can be installed on the left or right side of door.
The installation instructions which follow are meant to be general guidelines which.
Auto openers roller door opener installation manual.
12 1 3 step 11 repeat step 10 using number 3 hinges on the third door panel.
Disclaimer these instructions and other documents are intended for professional garage door installers.
Check that the panels supplied overlap the daylight opening width by 25 35mm each.